What is the Correct Operation Method of the Distribution Box during Cold Storage Installation?

During the installation of a cold storage, the operation of the cold storage distribution box is of great importance. However, most people are not well - versed in its normal operation. Let's take a look at the correct operation methods of the cold storage distribution box.

After the cold storage is installed, the wiring outside the cold storage distribution box must be protected properly. For example, wiring such as steel pipe hoses should be placed in areas that are less likely to be damaged. Otherwise, the wiring of the cold storage distribution box may suffer unnecessary damage.

After the cold storage is installed, the power cables between the distribution box and the machine tool should preferably be placed in the middle of the cable tray. The cable tray also needs a base for support. According to KuHua Refrigeration, when using the cable tray, it should never be in direct contact with the ground.

The piping outside the cold storage distribution box also needs to be unified, which is an important aspect after the cold storage installation. If there is a lack of uniformity, malfunctions are likely to occur frequently during later use, resulting in unnecessary maintenance costs. We hope everyone can keep this in mind.

When installing the cold storage, attention should be paid to the connection of the distribution box with the packaging machine or other heating equipment.

When wiring, keep it away from heat sources. The wiring should preferably be placed inside the connection box. For the connecting wires of the heater, glass or ceramic tube wires should be used.

For safety reasons, flammable wires should not be used.

All the wires outside the cold storage distribution box should be placed in the connection box when connecting. This is also an important part of the cold storage installation process.

In addition, there should be no joints in the middle of the connecting wires.

The protection level of the wire inlets of all connection boxes of the cold storage distribution box should meet the standard of IP55 or above. This is something that everyone should pay attention to during the cold storage installation.

For the relay terminal block, it is advisable to use two wires for connection. If more than three wires need to be connected, it is better to set up other terminal blocks. Otherwise, it will affect the normal use of the distribution box.

If the sensor is placed in an area that is easily damaged during wiring, a hose should be used for protection as much as possible. The hose should be directly installed at the root of the sensor. This is also something to be noted during the cold storage installation.

At the same time, after the cold storage is installed, the normal operation of the distribution box should be regularly inspected. Once potential hazards are detected, they must be dealt with immediately. Otherwise, it will affect the normal use and may even cause economic losses. We hope everyone attaches great importance to inspections.

The above are the correct operation knowledge of the distribution box during cold storage installation. To ensure the normal functioning of the distribution box, we need to pay attention to these aspects. This will play a supportive role in the normal use of the cold storage.